SAE AMS 4088J pdf download

SAE AMS 4088J pdf download.Aluminum Alloy,Drawn, Seamless Tubing 4.4Cu – 1.5Mg – 0.60Mn (2024-T3)Solution Heat Treated and Cold Worked.
1.1 Form:
This specification covers an aluminum alloy In the form of seamless, drawn tubing.
1.2 Application:
This tubing has been used typically for parts requiring a high-strength alloy and part is not welded, but usage is not limited to such applications.
2. APPLICABLE DOCUMENTS:
The issue of the following documents in effect on the date of the purchase order forms a part of this specification to the extent specified herein. The supplier may work to a subsequent revision of a document unless a specific document issue is specified. When the referenced document has been canceled and no superseding document has been specified, the last published issue of that document shall app’y.
2.1 SAE Publications:
Available from SAE. 400 Commonwealth Drive. Warrendale, PA 15096-0001.
AMS 2355 Quality Assurance Sampling and Testing, Aluminum Alloys and Magnesium Alloys,
Wrought Products, Except Forging Stock, and Rolled, Forged or Flash Welded Rings
MAM 2355 Quality Assurance Sampling and Testing, Aluminum Alloys and Magnesium Alloys,
Wrought Products, Except Forging Stock, and Rolled, Forged or Flash Welded Rings, Metric (SI) Units
AMS 2772 Heat Treatment of Aluminum Alloy Raw Materials
8.5Similar Specifications:
Federal WW-T-700/3, Temper T3, is listed for information only and shall not be construed as anacceptable alternate unless all requirements of this AMS are met.
5. PREPARATION FOR DELIVERY:
5.1 Identification:
Shall be in accordance with ASTM B 666B 666M.
5.2 Packaging:
5.2.1 Tubing shall be oiled. prior to shipment, with a light corrosion-inhibiting oil.
Tubing shafl be prepared for shipment in accordance with ASTM B 660, commercial practice, and in compliance with applicable rules and regulations pertaining to the handling, packaging, and transportation of the tubing to ensure carrier acceptance and safe delivery.
6. ACKNOWLEDGMENT:
A vendor shall mention this specification number and its revision letter in all quotations and when acknowledging purchase orders.
7. REJECTIONS:
Tubing not conforming to this specification, or to modifications authorized by purchaser, will be subject to rejection.
8. NOTES:
8.1 A change bar (I) located in the left margin is for the convenience of the user in locating areas where technical revisions, not editorial changes, have been made to the previous issue of this specification. An (R) symbol to the left of the document title indicates a complete revision of the specification, including technical revisions. Change bars and (R) are not used in original publications, nor In specifications that contain editorial changes only.
8.2 Dimensions and properties in inch/pound units are primary: dimensions and properties in SI units are shown as the approximate equivalents of the primary units and are presented only for information.
8,3 Terms used in AMS are clarified in ARP1 917.
8.4 Procurement documents should specify not less than the following.
AMS 4088J
Size of tubing desired
Quantity of tubing desired
8.5Similar Specifications:
Federal WW-T-700/3, Temper T3, is listed for information only and shall not be construed as anacceptable alternate unless all requirements of this AMS are met.