BS EN 840-4:2020 pdf download

BS EN 840-4:2020 pdf download.Mobile waste and recycling containers Part 4: Containers with 4 wheels with a capacity up to 1 700 1 with flat lid(s), forwide trunnion or BG- and/or wide comb lifting devices —Dimensions and design.
This document specifies dlmensons and design requirements of mobile waste and recycling containers with 4 wheels, with flat lid(s) and capacity up to 1 700 I to be used by wide trunnion or BG-lifting device and/or wide comb lifting device.
These containers are only approved for the before explicitly mentioned lifting devices.
2 Normative references
The following documents are referred to in the text in such a way that same or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 840.5, Mobile waste and recycling containers — Part 5: Performance requirements and test methods EN 840.6. Mobile waste and recycling containers — Part 6: Safety and health requirements EN ISO 11469, PlastIcs- Generic Identification and marking of plastics products (ISO 11469)
EN ISO 11:i. Refuse collection vehicles — General requirements and safety requirements — Part 1:
Rear loaded ref ase collection vehicles
3 Terms and definitions
Far the purposes of this document, the following terms and definitions apply.
ISO and IEC maintain terminological databases for use In standardization at the following addresses:
• IEC Electropedia: available at http://www.electropedia.org/
• ISO Online browsing platform: available at https://www.iso.ore/obp
NOTE Terms for components of mobile waste and recycling containers and lifting devices in three languages are given in Annex Aol EN 840-1:2020.
mobile waste and recycling container
appropriately designed container fitted with wheels intended to temporarily store waste
lifting device
structure which picks-up, tilts and empties containers
3.3
comb lifting device
lifting device in which the picking-up system consists of a row of teeth and a locking system to retain the container during emptying
3.4
trunnion lifting device
lifting device in which the picking-up system consists of a pair of arms with automatic locking mechanism to fit the trunnion to retain the container during emptying
3.5
BG lifting device
lifting device in which the picking-up system consists of a pair of arms with adaptors that fit the BG receivers and locks them in order to retain the container during emptying
Noteltoentry SeeFigures5and6.
3.6
volume
total space inside the container when the lid is closed
3.7
nominal volume capacity volume stated by the manufacturer
Note Ito entry: See Table I without tolerances.
Note 2 to entry: The English term capacity and the French term capadté” are translated in the German version by the term ‘Nennvolu men”.
3.8
nominal mass
mass, which is calculated as given in Clause 6
3.9
total permissible mass
mass of the container plus the nominal load
3.10
functional and safety dimension
essential dimensions which ensure the functionality and interchangeability of the container with the compatible lifting device and which are necessary for the operator’s safety and health
4 Volumes
This part of EN 840 IdentIfies the two classes of containers:
— Class I small size (nominal volume up to 1 050 I);
— Class II – large size (nominal volume between 1 050 land 1 700 I).
Within the two above•mentioned classes of containers the following volumes are identified: 7501. 1 000 I, 1 300 I, 1 400 I, 1 500 I, 1 6001 and 1 700 I. Nominal volumes different from those referenced can be used by agreement between user and manufacturer. The tolerance of the volumes shall be ± 5% maximum measured according to EN 840-5.