BS EN 61236:2011 pdf download
BS EN 61236:2011 pdf download.Live working – Saddles, stick clamps and their accessories.
— symbol IEC 60417-5216:2002-10 — Suitable for live working; double triangle (Annex A);
NOTE The eKed ratio of the height of the figure to the base of the triangle is 1.43 For the purpose of
oonv.ni.ric., this rabe can be b.twesn ihe values of 1,4 end 1.5
— number of the relevant IEC standard immediately adjacent to the symbol (IEC 61236).
Information or characteristics not required at the work site, such as year of publication of the standard, shall be provided by other means (bar codes, microchips, dc,) or shall be provided on the packaging.
4.6 Instructions for use
Each device shall come with the manufacturer’s instructions for use and care. These
Instructions shall be prepared In accordance with the general provisions given In IEC 61477. These instructions shall include at least
— maximum mechanical rating;
— recommended application(s);
— recommendations for cleaning. storage. transportation, periodic testing. refinishing and disposal.
5 Tests
5.1 General
This standard provides testing provisions to demonstrate compliance of the product with the
requirements of Clause 4. These testing provisions are primarily intended to be used as type tests for validation of the design input. Where relevant, alternative means (calculation, examination, tests, etc.), are specified within the test subclauses for the purpose of saddles. stick clamps and their accessories having completed the production phase.
To show compliance with this standard, the manufacturer shall prove that the type tests have been carried out successfully on at least three devices for each type.
However, when the differences between several types of device are limited In number, tests that are unaffected by the differing characteristics of the devices can be carried out on a single type of device, and the results can be used for the other device types.
The different type tests, and the order In which these tests are performed are given in Annex B.
The tests in Tables B.1, B.2, B.3 and BA of Annex B shall be performed, following the specified order
NOTE in Tabtes UI. 62. 6.3 and BA the numbers within parentheses provide reierence to the Subclause where th, relevant test is eicpaained For some families of devices. columns are divided in sub-columns equal to the numbe of mechanical tests to be applied to these devices these may be destructive). These subcolumns also show Ui, sequence of tests to be applied (for an example see Table B.5).
Any device falling to pass any one of the tests mentioned In Tables B.1. 8.2. B.3 and B.4 of Annex B shall result in the design being rejected.
5.2 Visual and functional inspection
Each device shall be visually Inspected to detect manufacturing defaults and to check proper functioning.
