BS EN ISO 4884:2019 pdf download
BS EN ISO 4884:2019 pdf download.Hard metals – Sampling and testing of powders using sintered test pieces (1So 4884:2019).
2 Normative references
The tollowing documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3327, Hordmetols — Determination of transverse rupw-e strength
ISO 3369, Impermeable sintered metal materials and hardmetals — Determination of density
ISO 3738-1, llardmetals — Rockwell hardness test (scale A) — Part 1: Test method
ISO 3738-2. IIardmetals — Rockwell hardness test (scale A) — Part 2: Preparation and calibration of standard test blocks
ISO 3954, Powders for powder metallurgical purposes — Sampling
ISO 4499-1, Hardmetals — Metallographic determination of microstructure — Part 1: Photomicrographs and description
ISO 4499-2, Hardmetals — Metallogrophic determination of microsrructure — Part 2: Measurement of WC grain size
ISO 4499-3, Hardmetals — Metallographic determination of microstructure — Part 3: Measurement of microst ructural features in Ti (C, N) and WC/cubw carbide based hardmetals
ISO 4499-4, Hardmetals — Metallographic determination of microstructure — Part 4: Characterisation of porosity, carbon defects and eta-phase content
ISO 6507-1. Metallic materials — Vickers hardness test — Part 1: Test method
ISO 6507-2, Metallic materials — Vickers hardness test — Part 2: VerEfication and calibration of testin,q machines
ISO 6507-3, Metallic materials — Vickers hardness test — Part 3: Calibration of reference blocks
ISO 6507.4, Metallic materials — Vickers hardness test — Pan 4: Tables of hardness values
ISO 28079, Hardmetals — Palm qvist toughness test
3 Terms and definitions
For the purposes of this document, the terms and definitions given in Iso 3954 apply and the following.
ISO and IEC maintain terminological databases for use in standardization at the lollowing addresses:
— ISO Online browsing platform: available at hLtpsJ/wwwJso.urjpbp
— IEC Electropedia: available at http://www.electropedia.org/
4 Sampling
4.1 Sampling from a lot shall be carried out in accordance with ISO 3954.
4.2 In the event that a hatch is blended into one lot in one blender as the last operation before separation into containers, then by agreement between producer and consumer, one or more test samples may be taken from the blender.
5 Preparation of test pieces
5.1 The test pieces shall be processed from the test sample in conformity with their grade and dimensions. All the test pieces for each type of testing shall be sintered simultaneously under the same conditions and in the same furnace.
5.2 To ensure that the characteristics of the test pieces prepared from the lot of powder are significant, the appropriate manufactunng conditions shall he used in the production of the test pieces.
5.3 The dimensions of the test pieces shall comply with the requirements of the relevant International Standards specified In Table I For the determination of porosIty one or more test pieces shall be sectioned to enable a total area of not less than 1 cm2 to be examined.
6 Testing
Tests on sintered test pieces from a lot of powder shall be carried out in accordance with the International Standards given in Table 1.
