ISO 8788:2000 pdf download
ISO 8788:2000 pdf download.Aerospace- Nuts, metric — Tolerances of form and position.
This International Standard defines the tolerances of form and position of metric nuts meant for aerospace construction. These tolerances comply with ISO 1101, ISO 2692 and ISO 5459.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of ISO and lEO maintain
registers of currently valid International Standards. I
ISO 1101:_i), Geometrical Product Specifications (GPS) Geometrical tolerancing Tolerancing of form, orientation, location and run-out.
ISO 2692:1988, Technical drawings — Geometrical tolerancing Maximum material principle.
ISO 5459:1981, Technical drawings Geometrical tolerancing Datums and datum-systems for geometrical tolerancing.
1) To be published. (Revision of ISO 1101:1983)
3 Types of nuts, illustration of tolerances of form and position, values See Table 1 for the tolerances of form and position to be applied in relation to the type of nut, Tables 2 to 11 for the illustration of tolerances of form and position for different types of nut. See Tables 12 and 13 for the values of the tolerances. In the “illustration” column, only one type of nut has been shown as an example, but the corresponding tolerance applies to all types of nut specified in the third column.