SAE AMS 6354E pdf download
SAE AMS 6354E pdf download.Steel, Sheet, Strip, and Plate 0.75Si – 0.62Cr – o.20Mo -0.10Zr(0.10 – 0.17C).
3.4 Quality:
The product, as received by purchaser, shall be uniform in quality and condition. sound, and free from foreign materials and from imperfectons detrimental to usage of the product.
3.5 Tolerances:
Shall conform to all applicable requirements of AMS 2252 or MAM 2252.
4. QUALITY ASSURANCE PROVISIONS:
4.1 Responsibility for Inspection:
The vendor of the product shall supply all samples for vendor’s tests and shall be responsible for the performance of all required tests. Purchaser reserves the right to sample and to perform any confirmatory testing deemed necessary to ensure that the product conforms to specified requirements.
4.2 Classification of Tests:
All technical requirements of this specification are acceptance tests and shall be performed on each
heat or lot as applicable.
4.3 Sampling and Testing:
Shall be in accordance with AMS 2370.
4.4 Reports:
The vendor of the product shall furnish with each shipment a report showing the results of tests for chemical composition of each heat and for average grain size, tensile properties, and bending of each lot, and stating that the product conforms to the other technical requirements. This report shall indude the purchase order number, heat and lot numbers, AMS 6354E, size, and quantity.
4.5 Resampling and Retesting:
Shall be in accordance with AMS 2370.
5. PREPARATION FOR DELIVERY:
5.1 Identificabon:
Shall be in accordance with AMS 2807.
5.2 Protective Treatment
The product shall be protected from corrosion pnor to shipment.
5.3 Packaging:
The product shall be prepared for shipment in accordance with commercial practice and in compliance with applicable rules and regulations pertaining to the handling, packaging, and transportation of the product to ensure carñer acceptance and safe delivery.
6. ACKNOWLEDGMENT:
A vendor shall mention this specification number and its revision letter in all quotations and when acknowledging purchase orders
7. REJECTIONS:
Product not conforming to this specification, or to modifications authorized by purchaser, will be subject to rejection.
8. NOTES:
8.1 A change bar (I) located in the left margin is for the convenience of the user in locating areas where technical revisions, not editorial changes, have been made to the previous issue of this specification. An (R) symbol to the left of the document title indicates a complete revision of the specification. including technical revisions. Change bars and (R) are not used in original publications, nor in specifications that contain editorial changes only.
8.2 The phrase “occasional grains as large as 3 permissible” has been deleted to clarify the intended use of ASTM E 112,
8.3 Terms used in AMS are clarified in ARP1917.
8.4 Dimensions and properties in inch/pound units are primary; dimensions and properties in SI units are shown as the approximate equivalents of the primary units and are presented only for information.
